BlackVue Hardwiring Kit 4.5m
Compatible BlackVue models
As listed by BlackVue. Not compatible with the DR750X-2CH LTE Plus.
Quick specs
- Enables 24-hour parking mode — by powering the camera from the fuse box.
- 12V and 24V support — with pass-through output at the vehicle’s voltage.
- Five fuse types covered — Micro2, Micro3, Mini, LPM and ATO, with fuses pre-installed.
- Everything in the box — 4.5 m cable, 8 fuse holders, pry tool and quick start guide.
- Fits the BlackVue ELITE series — plus DR590X, DR770X and DR970X models.
Why it stands out
What's in the box
BlackVue’s Elite cameras need a hardwired power cable for 24-hour parking mode. This BlackVue kit includes the cable, eight fuse holders across five fuse types and a pry tool, so you have everything for the install.
Which dashcams it fits
BlackVue lists this kit for the DR590X, DR770X, DR970X, DR970X Plus and ELITE series, and not the DR750X-2CH LTE Plus. On Dashcams.ae we pair it with the Elite 10 and Elite 8.
2 dashcams on Dashcams.ae list this as a matching accessory.
How the BlackVue kit powers parking mode
The kit connects the camera directly to the vehicle fuse box instead of the cigarette lighter socket, so the camera keeps power when the engine is off and can run its parking modes.
It works on 12V and 24V systems and passes the vehicle’s own voltage through to the camera.
- Input
- 12V or 24V
- Output
- Same as input (pass-through)
- Cable
- 4.5 m
- Fuse types
- Micro2, Micro3, Mini, LPM, ATO
Low-voltage protection and the UAE summer
Because the kit passes the vehicle voltage straight through, battery protection is set in the camera. Choose a higher cut-off in the BlackVue settings if your battery is older or the car sits for days.
The UAE summer is hard on car batteries, so check the setting after fitting.
Installation
Pick the fuse holder that matches your fuse box, fit it to a suitable fuse and route the 4.5 m cable behind the trim with the pry tool. The kit includes everything needed for most cars.
If you are not comfortable at the fuse box, a dash cam installer can fit it.
- The BlackVue hardwiring kit (cable, fuse holders, pry tool)
- A circuit tester to find the right fuses
Pros, cons & verdict
Pros
- Fuse holders for five fuse types included
- Pry tool included
- 12V and 24V support
- Fits the ELITE series
Cons
- Battery cut-off set in the camera
- Not for the DR750X-2CH LTE Plus
Our verdict
A complete hardwiring kit for the BlackVue Elite series, fuse holders and pry tool included
It covers five fuse types out of the box, supports 12V and 24V vehicles and fits the current BlackVue range. Battery protection is handled in the camera’s settings.
Who should buy it
Specifications
| Brand | BlackVue |
|---|---|
| Type | Hardwiring power cable kit |
| Cable length | 4.5 m |
| Input | 12V or 24V |
| Output | Same voltage as input |
| Fuse holders | 8, with fuses: Micro2, Micro3, Mini, LPM, ATO |
| Also included | Pry tool, quick start guide |
| Listed compatibility | DR590X, DR770X, DR970X, DR970X Plus, ELITE series (not DR750X-2CH LTE Plus) |
FAQ
Does it work with the BlackVue Elite 10?
Where is the low-voltage cut-off set?
Can I fit it myself?
Specification: BlackVue Hardwiring Kit 4.5m
|









